STEMMER IMAGING

CoaXPress Frame Grabber for following PC interface:
PCIe x8 (Gen2) for the acquisition of digital sources via 4 x DIN 1.0/2.3

• For area and line scan, monochrome and color cameras
• Max. image acquisition 2.5 GB/s (system-dependent)
• Power over CoaxPress (PoCXP)

Front-GPIO (DH60-27-pin connector):

• 4 in, 8 out
• 4 opto-coupled general inputs where 2 are shared acquisition trigger inputs

(RS-422/TTL/12V/24V

• 8 LVTTL general Outputs where 1 is shared as Strobe Output
• Quadrature (phase A & B) shaft encoder inputs for external web synchronization: RS-422 up to 10 MHz, with built in bi-directional

Features (selection):

• Supports CXP cameras with 4, 2 or 1 output channels of up to 6.25 Gbs per channel
• Supports monochrome and RGB cameras
• Bit depth: Mono: 8, 10, 12, 14 and 16-bit mono and 8, 10 and 12-bit RGB
• Maximum host bandwidth up to 3.4 GB/s
• 1 GB onboard frame buffer
• Output Lookup Table
• Flat Field/Flat Line Correction (8-bit/pixel only)
• Compliant with Teledyne DALSA Trigger-to-Image Reliability framework
• Comprehensive event notifications
• Timing control logic for camera triggers and strobe signals
• Trigger inputs are programmable as active high or low (edge or level trigger, at maximum input frequency of 100 KHz)
• External trigger latency less than 100 nsec

Software:

• Supports Sapera LT
• Drivers for Common Vision Blox available
• Supports Common Vision Blox

Supported operating systems:

• Windows 7, Windows 8.1, Windows 10 32- and 64-bit O/S