STEMMER IMAGING

LLM is also ideally suited to multispectral imaging solutions using specific wavelength LEDs rather than broad-spectrum white lights with optical filters in front of the sensor. This approach can greatly reduce the cost of multispectral imaging solutions.

The unit can be programmed easily by technicians of any level using an intuitive browser-based user interface to set image sequences and the appropriate intensities for each light. Programs can be saved on a microSD card for further use.

Each LLM program can contain up to six sequences with up to four lights or 4 segments in a ring light individually set to be off, continuously on, any intensity level in between, or even operating in OverDrive™ strobe mode to deliver higher light intensity in short bursts.

A sequence event containing from one to four sequences can be created. Once the event is activated the first sequence of lights is triggered and the camera is triggered. The LLM waits for the camera exposure to be completed before triggering the next sequence. This process is repeated for all the sequences chosen for the event.